Leander Replacement Variable Speed Control Board KIT EZ version

Product Description

Leander Replacement Variable Speed Control Board KIT

- EZ Version

The slower the table runs, the HARDER it is on your Motor. Run motor at full speed once a month for 10 minutes. This will clean the internal brushes...

This Leander Variable Speed Control Board is a COMPLETE EZ Replacement for most Variable Speed Leander table models. This Leander variable Speed Control Board kit requires some electrical knowledge and is a Medium to do job on our rating scale. It is highly suggested that you have electrical knowledge to replace the Leander variable Speed Control Board.

This Board is NO LONGER MADE FROM MFG. Replacement Kit works great for this type!!!

Kit Includes Variable Speed Board/On-Off Foot Pedal/New power cord and screws to attach to base.

If you read the instructions, and still would like me to assist via video tech support through the whole process. Just pay for the tech support on line and then make an appointment with Tiffany. https://chiropractictablepart.com/video-chat-for-chiropractic-table-assisted-tech-support-repair-or-trouble-shooting/

The normal $50.00 charge is DISCOUNTED by 25% after you purchase the part from us. (you will receive a discount code via email when you purchase the part)

$37.50 for the 15 Minutes, and that will be plenty of time.

Tools Needed: Cordless drill with phillips head bit & a small flat head screw driver

Leander EZ Variable Speed Control Box Install Instructions:

1. Disconnect power cord from the wall outlet!!

2. Remove old power supply from table. The 2 wires coming from your motor are the only wires you will need to keep. All other wires can be tied off and will not be used. Zip tie or black tape will work fine. Unless you have an elevation table, you will not need your old power cord or foot pedal. IF you do have an elevation table, you will need the elevation pedal and old power cord.

3. Feed blue & black wire coming out of the back of EZ Box into existing hole on table. The 2 wires from the motor will direct plug into the 2 blue & black wires. Plug in power cord on the EZ box and test ---- Check the variable flexion speed, on/off switch on front of EZ box, and foot pedal on/off. Make sure the motor is turning clockwise. If counter clockwise (disconnect power cord from the wall outlet!!) then simply reverse the blue & black wires going to the two motor wires.

4. Test fit power box to old hole on the motor cover - Try and cover as much of the factory hole as possible (see Link below).

   Leander Speed Control Board, Leander Speed Control Board, Leander variable Speed Control Board, replacement Leander variable Speed Control Boards, Leander Speed Control Board, Leander variable Speed Control Board, replacement leander parts