Leander Flexion Gear Box Adapter mounts to the gear box to remove any slip that the flexion mount may have. Works on old and new style tables.

The Leander Flexion Gear Box Adapter removes the most common problem for the clunk. This happens when the rear arm that attaches the push rod to the gear box slips. The Original design was bad, because it only uses small set screws to hold it tight to the shaft. This Leander Flexion Gear Box Adapter eliminates all slip. It use a Large 1/2 hardened bolt and never turns loose. The Leander Flexion Gear Box Adapter also gives you 3 adjustment holes for the depth of the flexion instead of the slide hole that slips! The main hole for the shaft is 7/8".

The bolt we send is ONLY for the Pushrod Mechlocks. If you have a flat plat, you will need to get the bolt from a hardware store.

Leander Flexion Gear Box Adapter, Leander Flexion Gear Box Large Adapter, Leander Gear Box Adapter, Leander Table Parts, Leander Parts